Data Loading...
QUICK START GUIDE Flipbook PDF
CAUTION: Save packaging or MobileDemand warranty will be void. Package must be used for future transport. Please visit o
119 Views
39 Downloads
FLIP PDF 431.21KB
QUICK START GUIDE
R
1.877.784.4338
CAUTION:
CONTENTS: T8700 xTABLET KIT
Save packaging or MobileDemand warranty will be void. Package must be used for future transport.
Before you begin . . .
(1) Recovery DVD for Vista (1) Downgrade DVD for XP
(1) T8700 xTablet
remove protective film 1 Gently Do not remove LCD screen protector
(1) AC power supply
Please visit our website www.ruggedtabletpc.com for an extensive array of optional accessories. Contact dealer for missing or damaged items.
2
Locate stylus storage on back of the T8700 Stylus storage location
Starting up the T8700 . . . 4
3
Back view of the T8700
Note: The battery may not be fully charged but can be used. For best results, allow your battery to fully charge, then calibrate the battery before using the T8700. After start up see “Managing Power” in the T8700 User’s Guide on the T8700 desktop for more information.
1 2 3 4
2
1
Connect the AC adapter power cord to the AC adaptor Connect the AC adapter to the DC power port on the bottom side of the T8700 Connect the AC adapter power cord to an AC outlet Press
on the front to activate the T8700
Screen Adjustment . . . Use the following key combinations to make quick adjustments to the viewing area:
+
7 Rotates screen 90°
+ +
4 Turns keypad backlighting on
Note: See the T8700 xTablet User’s Guide for more information
Toggles between dual input (touch and digitizer)
0 and digitizer only mode
+
Darkens LCD panel Lightens LCD panel
+
+
between normal input 5 Toggles and calculation mode
Calculation mode:
+
= Minus
= Plus
Decreases speaker volume
+
Increases speaker volume
Tab
= Decimal
Digitizer & Touch Panel Calibration . . .
The touch panel is a thin membrane on the top of the LCD that responds to pressure from your stylus or finger and moves the cursor on the screen. If you notice the stylus tip or finger touch-point does not match the cursor on the screen - you should calibrate the digitizer and the touch panel. Stylus Note: See the T8700 xTablet User’s Guide for more information
Touch Panel (Finger or Stylus) On the T8700 desktop, to calibrate touch panel; Using Fn+0 verify tablet is in TouchScreen Mode. Tap (Start) > Control Panel (Classic View) > TouchSet Utility > Calibration > (Select desired options) Calibrate > (Touch crosshairs) > Close
Digitizer (Stylus) On the T8700 desktop, to calibrate digitizer; Using Fn+0 verify tablet is in Digitizer Mode.
Control Panel TouchSet Utility Calibration Calibrate Close
Control Panel Tablet PC Settings Calibrate Okay
Fn
7
8
9
4
5
6
1
2
3
Tab
0
Fn
Okay
Tap (Start) > Control Panel > Tablet PC Settings > (general tab) Calibrate > (Touch crosshairs) > Okay > Okay
7
8
9
4
5
6
1
2
3
Tab
0
Check Battery Power . . .
Note: See “Managing Power” in the T8700 xTablet User’s Guide for detailed information.
There are two methods to check battery power:
1
Start Control Panel Power Options Windows Mobility Center
or
Fn
7
8
9
4
5
6
1
20
3
Tab
Fn
2
7
8
9
4
5
6
1
2
3
Tab
0
Double click Battery or Power Cord Icon
Recharging the Battery . . .
Caution: During long term storage, you must recharge the battery to its full capacity at least every three weeks or you damage the battery. Start from the original MobileDemand shipment date or from the date when you put the T8700 into long-term storage.
Blinking Red - battery power critically low - recharge Steady Orange - battery charging Steady Green - battery fully charged Front lower left view of T8700 with blow-up of the Battery Status Indicator
Note: The T8700 can run on a fully-charged Li-Ion battery for about six and one half hours depending on power management settings and radio activation.